
WEEK TWENTY-ONE: Kitchen Counter
Kitchen Counter
Counter top traced, holes for undermount sink and drop-in stove measured/cut. I've always wanted to experiment with these geometric wood pattern blocks (flashback to 2nd grade math) and after determining that it wasn't such a good flooring choice I decided to use it as the counter surface. I implemented a slightly more intricate radial pattern at the peninsula while opting for a more regular pattern across the rear and around appliances. Awaiting more blocks

WEEK TWENTY: Curved Base Cabinet, Bedroom Opening & Floor Repairs
Curved Base Cabinet
Some time ago I came across a curved base cabinet/peninsula design on the VTT forum I joined (here is the image however I haven't been able to trace the actual thread). While this was built for an Airstream trailer I fell in love with the idea and feel like the small gesture added a lot of usable space without taking up much square footage. I drew up the framing plans in SketchUp and got to kerfing. I did run into a conflict with the sink vent which led t

WEEK NINETEEN: Moving Inside, More Ceiling Panels and Kerfing
Tow-tal Success
The ramp is in and we managed to tow the Shasta down the driveway, into the street, across the bumpy lawn and up the ramp while staying completely intact. I even got to hitch my first ride since I've owned it. Smooth sailing. 2nd Ceiling Panel
All roof seams sealed with Eternabond RoofSeal Repair Tape. It adheres to all substrates and is pressure activated to create a water tight seal against any possible leaks. I will be coating the roof but decided to use

WEEK EIGHTEEN: Shellac Troubles, LVT Flooring & Cabinet Finishes
Ceiling Shellac & Moisture
When I chose shellac for the ceiling finish I was aware that it didn't react well with moisture. Now that it's getting cooler out, there's condensation overnight and I've found tiny pin-sized bubbles where the shellac is raising from moisture. Fortunately shellac is really easy to sand down and re-finish (one of the greatest benefits) so it won't be an issue. Just means no more panels will be put in before the camper gets inside. Hopefully within t

Let there be light (and DOORS)!
It's complete... almost! New lights and outlets installed (thanks to my stepfather). New electrical panel, mast and meter hooked up. Barn doors built by a great guy down the street and there's now a 9' x 9' opening. Success! All it needs now, is a ramp.

WEEK SEVENTEEN: Bathroom Plumbing, Cabinet Updating and Another Ceiling Panel
Bathroom Plumbing
Before I can frame in any part of the bathroom I have to resolve 1) the broken wastewater (guillotine) valve on the exterior and 2) the closet valve on the interior where the toilet connects to the tank. I had an on-site RV service guy inspect it and all can be fixed. The handle of the wastewater valve is broken off so it needs to be cut off and replaced completely. The closet valve is trickier to replace since it's threaded through and sandwiches the 3/4"