
WEEK FIFTY & FIFTY-ONE: Exterior Door, Roof Insulation, Trim & Battery Power!
Exterior Door The exterior door jamb is constructed of 1x3 square edge boards that are fastened into the 1x wall framing; this gives the proper depth for the door to recess into the opening. The door threshold is a metal pan and while this is in place, it's pretty beat up and I'm leaning towards having it re-fabricated. To be continued. The door closes, and all edges sealed with foam weatherstripping that I grabbed at Lowes. Roof Insulation The roof will be insulated with two

WEEK FORTY-EIGHT & FORTY-NINE: Roof Curbing, Exterior Skins & Electrical
Roof Curbing After adjusting the wheel stops I'd been using the camper was rolled fully out of the building in order to better access the roof. I installed the remaining rafters and my electrician routed his wiring as needed; since it typically ended up being the most direct path, a majority of the wiring is run up in the roof cavity.
I'm replacing the metal roof with a new Dicor membrane roof. The wiring will be sandwiched within 3/4" - 2" of rigid insulation and then 1/8"